Search results

Until there is an IPK for pyPenNotes, you may want to create a desktop icon manually.

However, using the u-boot console you can manually enable fast charging. See [[U-boot#Battery_charger_related]] for more infor ... you can [[Manually_using_GSM | manually use GSM]], [[Manually_using_SMS | manually use SMS]], or you can start playing with the [[GPS]].

Rest needs to be done on the command-line [[manually using GSM]] and [[manually using GPRS]], until [[gsmd]] supports more.

...you can have a look in gsmd logs or use the instructions detailed in the [[Manually using GSM]] page and issue the ''AT+CIMI'' command. However, using the u-boot console you can manually enable fast charging. See [[U-boot#Battery_charger_related]] for more infor

''See [[manually using GPRS]].'' ''See [[manually using Bluetooth]].''

...arty. You can either depend on network decision ("By network") or force it manually ("Manual") This page can be used to monitor GPS status. You either have to turn GPS on manually or start another application to enable the GPS.

...so the program watches /dev/nmeaNP instead. You will need to launch gllin manually. * gllin MUST be started manually (execute "gllin" from terminal)

{{note|I had a problem where I was trying to manually install a package that had dependencies. The dependencies had a bad signat

...спользовании cu, you may want to refer to the article about [[manually using GSM]] for more information. ...кнут затруднения, обращайтесь к статье [[manually using GSM]] за дополнительными деталями настр

...e [[How to use bluetooth to transfer data between Neo and Desk-top]] and [[Manually using Bluetooth]]. ...4] After connecting using the GUI, you may also need to run "udhcpc eth0" manually in the terminal to get DNS entries added to your resolv.conf. You may also

If you want to run checkFastCharge manually, without the /etc/init.d script... Options are only available if you run the script manually, rather than through /etc/init.d

to handle reconnects manually.

...rop-down & correct them as necessary than to type all your contact info in manually on the neo keyboard, which was my option before I wrote this :-)

...sed the gui script from [http://wiki.openmoko.org/wiki/Manually_using_GPRS Manually using GPRS]||No

To manually restore one of the state files, To manually control the switch between Speaker and headset:

... then you need tell the package manager to update them, or you can do that manually with

If no context rules are defined the profile can only be activated manually and will remain in force until context awareness turned back on or another

... then you need tell the package manager to update them, or you can do that manually with

'''GPRS''': См. [[Manually using GPRS]] '''Bluetooth''': См. [[Manually using Bluetooth]]

= Building manually = ...he FsoMakefile are *exactly* the same configuration files you would create manually. So I just don't get why people say that using a Makefile doesn't tell you