Search results

* If you manually register to the gsm network (by toggeling the "Register" checkbox) Settings For details and background information on GPRS see [[Manually using GPRS]].

See [[Manually using Bluetooth]], which also explains pand networking for setting up a tcp

I got the values by manually browsing the site: http://buildhost.automated.it/OM2007.2 and choosing the

This page explains how you can manually re-flash the [[U-Boot]] into your Neo1973. It is basically the manual task

... use it. There is also [[Python ncurses]] for character user interfaces. [[Manually using Bluetooth]] is partially based on using Python.

... a (modified [for powering FreeRunner]) powered USB hub (see below), or by manually injecting power into the attached USB device (and Neo FreeRunner) via one o You can manually set the charge rate. See [[Forcing_fast_charge_mode]]

... gps application, e.g. like the one in [[Zhone]]. For the records, one can manually turn on the gps device using

... After this rebooting is required. Then go to /etc/resolv.conf and fill it manually by just using the content of this file on your local machine, or DNS addres

... then you need tell the package manager to update them, or you can do that manually with

* To delete a feed you must edit ~/.pyFeedRead.data manually

Until there is an IPK for pyPenNotes, you may want to create a desktop icon manually.

However, using the u-boot console you can manually enable fast charging. See [[U-boot#Battery_charger_related]] for more infor ... you can [[Manually_using_GSM | manually use GSM]], [[Manually_using_SMS | manually use SMS]], or you can start playing with the [[GPS]].

Rest needs to be done on the command-line [[manually using GSM]] and [[manually using GPRS]], until [[gsmd]] supports more.

...you can have a look in gsmd logs or use the instructions detailed in the [[Manually using GSM]] page and issue the ''AT+CIMI'' command. However, using the u-boot console you can manually enable fast charging. See [[U-boot#Battery_charger_related]] for more infor

''See [[manually using GPRS]].'' ''See [[manually using Bluetooth]].''

...arty. You can either depend on network decision ("By network") or force it manually ("Manual") This page can be used to monitor GPS status. You either have to turn GPS on manually or start another application to enable the GPS.

...so the program watches /dev/nmeaNP instead. You will need to launch gllin manually. * gllin MUST be started manually (execute "gllin" from terminal)

{{note|I had a problem where I was trying to manually install a package that had dependencies. The dependencies had a bad signat

...спользовании cu, you may want to refer to the article about [[manually using GSM]] for more information. ...кнут затруднения, обращайтесь к статье [[manually using GSM]] за дополнительными деталями настр

...e [[How to use bluetooth to transfer data between Neo and Desk-top]] and [[Manually using Bluetooth]]. ...4] After connecting using the GUI, you may also need to run "udhcpc eth0" manually in the terminal to get DNS entries added to your resolv.conf. You may also