Nand erase

From Openmoko

Revision as of 11:51, 27 September 2007 by Pudelfish (Talk | contribs)

Jump to: navigation, search

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to 

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo: 

cu -l /dev/ttyACM0

After connecting, you should get a prompt, where you can write: 

nand erase clean rootfs
nand erase clean kernel

To exit cu you need to type: 

~.
Retrieved from "http://wiki.openmoko.org/index.php?title=Nand_erase&oldid=19454"
Personal tools

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to 

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo: 

cu -l /dev/ttyACM0

After connecting, you should get a prompt, where you can write: 

nand erase clean rootfs
nand erase clean kernel

To exit cu you need to type: 

~.