View source for Disassembling Neo 1973

From Openmoko

Jump to: navigation, search

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Administrators.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page:

Templates used on this page:

Return to Disassembling Neo 1973.

Retrieved from "http://wiki.openmoko.org/wiki/Disassembling_Neo_1973"
Personal tools

Disassembling the Neo1973

NOTE: This page was written as of GTA01Bv3 hardware revision and might need updating soon


Back side of Neo1973

Gta01b v3 case back white.jpg

Opening back cover

Gta01b v3 case back open white.jpg

NOTE: You now need to remove the two Torx screws (T6x40)


Carefully remove top cover

Gta01b v3 case side opening white.jpg

Top case lid removed

Gta01b v3 case top open white.jpg

Lifting the PCB on the left side

NOTE: You have to bend the plastic case a bit outwards until the headphone jack on the left side of the device becomes loose


Gta01b v3 case top open pcb lift white.jpg

Removing PCB from case

NOTE: Since the PCB now is loose on one side, you can carefully pull the USB socket and GPS antenna connector out of the right side of the case, and then flip the PCB upwards


Gta01b v3 case top open pcb lifted.jpg