I2C Humidity Sensor
From Openmoko
(SHT21 digital humidity sensor) |
|||
(4 intermediate revisions by one user not shown) | |||
Line 1: | Line 1: | ||
− | The SHT21 is a digital humidity and temperature sensor with a easy to use I2C interface. | + | =General description= |
+ | The [http://www.sensirion.com/de/01_humidity_sensors/05_humidity_sensor_sht21/00_humidity_sensor_sht21.htm SHT21] from Sensirion is a digital humidity and temperature sensor with a easy to use I2C interface. It connects to your Freerunner just like the [[I2C Pressure Sensor]]. | ||
A simple kernel driver is already available from [http://gitorious.org/freerunner-navigation-board/sht21 here]. | A simple kernel driver is already available from [http://gitorious.org/freerunner-navigation-board/sht21 here]. | ||
+ | |||
+ | =Mounting= | ||
+ | The relative humidity depends on the ambient temperature. This makes it rather difficult to find the best mounting place for the sensor. The requirements are: | ||
+ | * contact with fresh air | ||
+ | * minimize errors introduced through heat from other electronic components. | ||
+ | |||
+ | ==Possible mounting places== | ||
+ | * next to the GPS antenna | ||
+ | * inside the GSM antenna | ||
+ | * behind the speaker holes | ||
+ | * ... | ||
+ | |||
+ | I tried the first two options. After drilling small holes both places can be used, but even without top cover I was able to measure a temperature difference of about one degree celsius between the inside and outside of the case. | ||
+ | |||
+ | [[Category:Accessories]] |
Latest revision as of 17:49, 9 September 2010
[edit] General description
The SHT21 from Sensirion is a digital humidity and temperature sensor with a easy to use I2C interface. It connects to your Freerunner just like the I2C Pressure Sensor.
A simple kernel driver is already available from here.
[edit] Mounting
The relative humidity depends on the ambient temperature. This makes it rather difficult to find the best mounting place for the sensor. The requirements are:
- contact with fresh air
- minimize errors introduced through heat from other electronic components.
[edit] Possible mounting places
- next to the GPS antenna
- inside the GSM antenna
- behind the speaker holes
- ...
I tried the first two options. After drilling small holes both places can be used, but even without top cover I was able to measure a temperature difference of about one degree celsius between the inside and outside of the case.