Revision as of 22:31, 5 January 2009

Steps and Tips about Wrench tool in ASU theme

Wrench probably used utility enlightenment_remote

This tool is able to

Load, Unload and List modules ( ENABLED = AUTOSTART, module must be LOADed before doing this )
Restart enlightenment, reboot OM, logout from session
Manage fonts, virtual desktops, winlist and process freeze detection&killing
And a lot of less important (some not available on FR) functions

To use it from SSH you need to setup environment variable E_IPC_SOCKET. Because it points to a file, it isn't hard to locate it. Just do this:

ls /tmp/enlightenment-root

For reply "disp-:0.0-2166|0" do

NOTE: Don't forget to escape colon (":") and remove anything after pipe ("

export E_IPC_SOCKET=/tmp/enlightenment-root/disp-\:0.0-2166

Now you should be able to use this tool from SSH connection

There is a program to edit Enlightenment .cfg files, you'll need it..

More instructions should appear soon, as my research goes on..

@@ Line 24: / Line 24: @@
 Now you should be able to use this tool from SSH connection
-== eet -- '''Way to change enlightenment .cfg files''' ==
+== Adding wrench to ASU theme ==
-I've got recently this mail from enlightenment mailing list:
+There is a [[Enlightenment .cfg|program to edit Enlightenment .cfg]] files, you'll need it..
-you have to use "eet" command line utility, it is the tool that reads
+More instructions should appear soon, as my research goes on..
-.src and turns then into .cfg if you check out Makefile (and
-Makefile.am).
-  eet -l e.cfg  # list all keys, usually just "config"
-  eet -d e.cfg config e.src # writes human readable values to file e.src
-  $EDITOR e.src # change whatever you like
-  eet -e e.cfg config e.src 1  # compile human readable values to binary form and use compression
-If you find that useful and want to help, please create a wiki page
-with your new knowledge.
-More complete instruction will appear tomorrow