Talk:Qtopia / Qt Extended on FreeRunner
Mounting the jffs file as described did not work for me. Instead I did the following:
mknod /dev/mtdblock0 b 31 0
losetup /dev/loop0 <rootfs.jffs2 file>
echo "/dev/loop0" > /sys/module/block2mtd/parameters/block2mtd
mount -t jffs2 /dev/mtdblock0 <mountpoint>
This seemed to work out alright.
I had pretty good luck with the procedure on the Qtopia on FreeRunner page using KnoppMyth 5.5 for my linux. Had to su but few problems. The only part I didn't figure out was the -C switch in the tar command. Failed every time. Worked around it.
A problem I had was with "Installing Kernel" instructions : instead of putting uImage.bin on the first partition in /boot folder, I had to put it directly in / (without that I couldn't boot). If someone else can reproduce the problem, I will edit the article. -Xavier_OM
- Same here I have to put uImage directly to / (not to /boot) -PipBoy2000
- Same here too. Should I change it on the page? --Nowic 16:24, 7 August 2008 (UTC)
How are you all (who have successfully booted to SD) partitioning your cards?
Also, what (if any) changes did you make to u-boot environment? I was unable to make any of my changes stick, so I couldn't add support for ext3.