m (sig fix)
m (added source of commands)
|Line 42:||Line 42:|
==debugging fso ==
==debugging fso ==
Revision as of 10:35, 22 August 2008
I remember seeing a umount /media/card command on this page which i don't see anymore. That's needed or you will get
/dev/mmcblk0p1 is mounted; will not make a filesystem here!
Fdisk will also complain
WARNING: rereading partition table failed, kernel still uses old table: Device or resource busy
I needed to umount and rewrite the partition table in order for /dev/mmcblk0p2 to appear.
Why don't we boot from NAND?
What's the reason for two partitions? Is it because ext2load was broken? Can we just upgrade u-boot and use one partition?
Is there any need for a swap partition?
--Brian 252 15:22, 8 August 2008 (UTC)
Touch screen calibration
Few days ago there was added calibration for gta02. It doesn't work correctly on my freerunnuer (the mouse pointer doesn't move where I click ant the touchscreen area is about 1/3 smaller then the screen). I tried /etc/pointercal from qtopia and openmoko but it is the same as with parameters from this wiki. Has somebody a tip how to fix this?
--Jakubzeman 07:42, 8 August 2008 (UTC)
I'm using lenny. Oh and if some one wants to see if they can get a debian based kernel / merge / get some more modules from debian / general modules into a kernel for other hardware (such as a rt73 chipset wireless card that would be great :) ) Dbmoodb 08:09, 8 August 2008 (UTC)
Thanks for suggestion. I'll try it (and I'll report if I'm successful or not). --Jakubzeman 08:56, 8 August 2008 (UTC)
If the sound card is configured properly but there's no sound coming out of the Freerunner, it most likely helps to restore an appropriate statefile from the tgz above which are also available on the Openmoko svn (/trunk/src/target/audio/om-gta0*).
For simple sound output to the internal stereo speakers, do:
alsactl -f /path/to/statefiles/stereoout.state restore
--Tanuva 12:59, 21 August 2008 (UTC)
The following are taken instructions are taken from lindi on irc.
/etc/init.d/frameworkd stop /etc/init.d/fso-frameworkd stop add 'log_level = DEBUG' to '[ogsmd]' in /etc/frameworkd.conf run "frameworkd" and watch the output
--Dbmoodb 08:34, 22 August 2008 (UTC)