Nand erase

From Openmoko

(Difference between revisions)
Jump to: navigation, search
m (chown uucp.uucp /dev/ttyACM0 => sudo chown uucp.uucp /dev/ttyACM0)
Line 1: Line 1:
 
To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to  
 
To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to  
  
chown uucp.uucp /dev/ttyACM0
+
sudo chown uucp.uucp /dev/ttyACM0
  
 
to get the necessary right (even as root). Using cu, you can then access the Neo:
 
to get the necessary right (even as root). Using cu, you can then access the Neo:

Revision as of 19:18, 18 September 2007

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt, where you can write:

  1. nand erase clean rootfs
  2. nand erase clean kernel
Personal tools

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt, where you can write:

  1. nand erase clean rootfs
  2. nand erase clean kernel