Nand erase

From Openmoko

(Difference between revisions)
Jump to: navigation, search
(catchg)
Line 17: Line 17:
  
 
  ~.
 
  ~.
[[Category:Technical ]]
+
[[Category:Technical]]
[[Category:Software]]
+
[[Category:Software (non openmoko)]]
 
[[Category:Documentation]]
 
[[Category:Documentation]]

Revision as of 16:03, 6 July 2008

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase rootfs
nand erase kernel

To exit cu you need to type:

~.
Personal tools

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase rootfs
nand erase kernel

To exit cu you need to type:

~.