Nand erase

From Openmoko

(Difference between revisions)
Jump to: navigation, search
(added nand erase warning)
(corrected nand erase command)
Line 11: Line 11:
 
{{warning|Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.}}
 
{{warning|Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.}}
  
  nand erase clean rootfs
+
  nand erase rootfs
  nand erase clean kernel
+
  nand erase kernel
  
 
To exit cu you need to type:
 
To exit cu you need to type:
  
 
  ~.
 
  ~.

Revision as of 20:44, 15 January 2008

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase rootfs
nand erase kernel

To exit cu you need to type:

~.
Personal tools

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase clean rootfs
nand erase clean kernel

To exit cu you need to type:

~.