Gpsd

From Openmoko

(Difference between revisions)
Jump to: navigation, search
(PMB 2520 Hammerhead)
(GPS on GTA01)
Line 46: Line 46:
  
 
== GPS on GTA01 ==
 
== GPS on GTA01 ==
 +
 +
At the GTA01, the host processor is a SC2410..
 +
 +
=== Hammerhead on the GTA01 ===
 +
 +
On the GTA01, the Hammerhead are configured that connected with the host processor through the UART. The UART of data output/input is connected to the UART 1 of the SC2410. The UART of the hardware flow control is connected to the UART 2 of the SC2410.

Revision as of 03:57, 8 February 2007

Contents

GPS

GPS(Global Positioning System)

AGPS

PMB 2520 Hammerhead

The PMB 2520 Hammerhead is a IC sulution for GPS that producted by the Infineon Technologies. It allows the usage of assistance data by surpporting A-GPS standards.

Modules of the Hammerhead

The Hammerhead consists of the following modules:

  • RF front-end with on-chip, high gain and low noise, LNA, I/Q mixers, on-chip polyphase complex IF filter, digitally controlled AGC, and 3-bits ADC for the I and Q paths.
  • Sigma-Delta RF PLL with on-chip PCO and on-chip loop filter.
  • Embedded PLL and NCO for baseband clock generation.
  • Multiple channels digital mixers and parallel correlator engines to enable real time correlation of the PRN code for up to 14 satellites.
  • Post processor including peak detection logic
  • SRAM for storing correlation results

Host Interface

The Hammerhead integrates 3 serial interfaces:

  • UART
  • I2C
  • SPI

The UART in the Hammerhead is a full-duplex UART interface. It is fixed in 8N1(8 data bits, no parity, 1 stop bit) mode. On the GTA01, the host processor connect with the Hammerhead through the UART.

Host software Architecture

The Hammerhead driver software is delivered as a library. The library has two seperate interfaces for the software. One part of them provides an interface to communicate with the high level software. The other part is the HAL(Hardware Abstraction Layer), it is used to communicate with the system.

The library provides the following infomations to the high level software:

  • Position data
  • Library status

The high level software sends the following messages to the library:

  • Assistance data
  • Positioning Commands
  • Configuration Commands
  • Time-out and Packet Available

The library communicates with the system at the following part:

  • Communications Drivers
  • System Timer
  • NV storage
  • Log buffer

GPS on GTA01

At the GTA01, the host processor is a SC2410..

Hammerhead on the GTA01

On the GTA01, the Hammerhead are configured that connected with the host processor through the UART. The UART of data output/input is connected to the UART 1 of the SC2410. The UART of the hardware flow control is connected to the UART 2 of the SC2410.

Personal tools

GPS

GPS(Global Positioning System)

AGPS

PMB 2520 Hammerhead

The PMB 2520 Hammerhead is a IC sulution for GPS that producted by the Infineon Technologies. It allows the usage of assistance data by surpporting A-GPS standards.

Modules of the Hammerhead

The Hammerhead consists of the following modules:

  • RF front-end with on-chip, high gain and low noise, LNA, I/Q mixers, on-chip polyphase complex IF filter, digitally controlled AGC, and 3-bits ADC for the I and Q paths.
  • Sigma-Delta RF PLL with on-chip PCO and on-chip loop filter.
  • Embedded PLL and NCO for baseband clock generation.
  • Multiple channels digital mixers and parallel correlator engines to enable real time correlation of the PRN code for up to 14 satellites.
  • Post processor including peak detection logic
  • SRAM for storing correlation results

Host Interface

The Hammerhead integrates 3 serial interfaces:

  • UART
  • I2C
  • SPI

The UART in the Hammerhead is a full-duplex UART interface. It is fixed in 8N1(8 data bits, no parity, 1 stop bit) mode. On the GTA01, the host processor connect with the Hammerhead through the UART.

Host software Architecture

The Hammerhead driver software is delivered as a library. The library has two seperate interfaces for the software. One part of them provides an interface to communicate with the high level software. The other part is the HAL(Hardware Abstraction Layer), it is used to communicate with the system.

The library provides the following infomations to the high level software:

  • Position data
  • Library status

The high level software sends the following messages to the library:

  • Assistance data
  • Positioning Commands
  • Configuration Commands
  • Time-out and Packet Available

The library communicates with the system at the following part:

  • Communications Drivers
  • System Timer
  • NV storage
  • Log buffer

GPS on GTA01