Disassembling Neo1973/ru - Revision history

DolfjeBot1: Replacing 'OpenMoko' with 'Openmoko'

2008-08-22T22:51:27Z

Replacing 'OpenMoko' with 'Openmoko'

Dolfje at 22:51, 20 August 2008

2008-08-20T22:51:11Z

Kaa: /* Снимаем заднюю панель */

2008-06-30T05:37:33Z

‎Снимаем заднюю панель

Kaa: /* Снимаем заднюю панель */

2008-06-30T05:36:37Z

‎Снимаем заднюю панель

Mkrentovskiy at 11:48, 16 September 2007

2007-09-16T11:48:56Z

New page

{{note| Данная страница дает инструкции по вскрытию платформы GTA01Bv3. Будущие выпуски, возможно, будут открываться иначе. Пока предполагается, что продаваемая версия GTA01B4 и будущая массовая [[GTA02#.22Phase_2.22_.28GTA02.2C_.22Mass_Market.22.29|GTA02]] будут поставляться в том же корпусе. }}

== Задняя панель Neo1973 ==
...изображена на нижеприведенной фотографии. Отчетливо виден логотип и текст OpenMoko.

[[Image:Gta01b v3 case back white.jpg|700px]]

== Снимаем заднюю панель ==

Для снятия панели аккуратно отожмите ногтем небольшие пластиковые зажимы и снимите крышку.

{{note| the back is not hinged, as it may appear in this picture; lift both sides away equally to avoid breaking the small tabs.}}

[[Image:Gta01b v3 case back open white.jpg|700px]]

Please note the 27 x 9 x 6 mm space above the sim & memory cards after inserting the battery. This could maybe be of some use for 3rd party electronics.

[[Image:Gta01b v4 space next to battery.jpg|700px]]

{{note| In order to remove the front cover, you now need to remove the two Torx screws (T6x40)}}

== Carefully remove top cover ==
[[Image:Gta01b v3 case side opening white.jpg|700px]]

To remove the top cover, after removing the two Torx screws, ''carefully'' squeeze the end of the supplied guitar pick between the cover and the case at the bottom of the device, and then slide the pick up to the top on one side (do not twist the pick). As you slide the pick along, the case retaining clips should come apart with a snapping sound. Repeat the procedure for the other side of the device. To unclip the last remaining large retaining clip at the top, slide the pick all the way to the top (this can be difficult) and then press it in at the centre. By ''careful'' application of force the clip will detach and the cover can then be removed.

== Top case lid removed ==
[[Image:Gta01b v3 case top open white.jpg|700px]]

Visible in this image, from the right, going clockwise.

*The blocky device at the far right is the GPS antenna.
**To the left of this, there are two gold pads, which are where the earpiece speaker connects.
*The [[Debug Board]] connector.
*At the left, the black semicircular device is the GSM antenna.
**Immediately to its right, the small circular black/gold object is the microphone
*At the top right, the ''Aux button''
*Right below it seems to be a small battery. It can also be seen on the picture below.

In the middle is the touchscreen LCD, the touchscreen printed wire can be seen beginning at the bottom left of this, through the glass.

== Lifting the PCB on the left side ==
{{note|You have to bend the plastic case a bit outwards until the headphone jack on the left side of the device becomes loose}}
[[Image:Gta01b v3 case top open pcb lift white.jpg|700px]]
Its not shown in this picture, but I've found that it helps to slide the AUX button out of the case before trying to remove the PCB. This allows you to get a firm hold on the PCB while gently bending the case to free the headphone jack and plastic retaining clips.

== Removing PCB from case frame ==
{{note|Since the PCB now is loose on one side, you can carefully pull the USB socket and GPS antenna connector out of the right side of the case, and then flip the PCB upwards}}
[[Image:Gta01b v3 case top open pcb lifted.jpg|700px]]

This shows:
*At the top on a green board, the bluetooth module, and the square bluetooth antenna.
*The headset jack is to the right of this.
**Immediately below the headset jack is the [[Neo1973 Battery]] connector.
**Below the [[Neo1973 Battery]] connector, the two gold pads feed the vibrator motor.
*To the right of the headset jack is the left speaker connector.

On the other side of the PCB, going from bottom-right corner down-left.

*The small circular connector is the GSM connector to which an external aerial can be connected with the back removed, or with an alternative back.

*To the left of this is the right speaker connector.
*One of the button switches.
*USB port.
*Micro-SD slot
*SIM slot - overlaying the Micro-SD slot when present.
*Gold GPS antenna connector.
**Immediately above this with the grey wire connection is the connection to the built in GPS antenna.

On the case picture below, you can see the left and right speakers under the translucent plastic, and the vibrator motor in the middle.

== Empty case frame ==

[[Image:Gta01b v3 case empty white.jpg|700px]]

You can actually see the two stereo speakers beneath the translucent cover, and next to it the small vibrator motor.

Next to the top of the picture is a hole near the speaker.
The external GSM antenna connector is accessed through this hole.

== GSM Antenna ==

[[Image:Gta01b v3 gsm antenna.jpg|700px]]

<span id="bottom"></span>
{{Languages|Disassembling_Neo1973}}

[[Category:Neo1973 Phase 1 related]]
[[Category:Neo1973 Phase 0 related]]

@@ Line 14: / Line 14: @@
 [[Image:Gta01b v3 case back open white.jpg|700px]]
-Пожалуйста, обратите внимание на пространство размером 27 x 9 x 6 мм над слотами для sim карты и карты памяти, которое остается после установки аккумулятора. Оно может быть использовано для установки дополнительной электроники от стороннего производителя.
+Обратите внимание на пространство размером 27 x 9 x 6 мм над слотами для sim карты и карты памяти, которое остается после установки аккумулятора. Оно может быть использовано для установки дополнительной электроники от стороннего производителя.
 [[Image:Gta01b v4 space next to battery.jpg|700px]]

@@ Line 2: / Line 2: @@
 == Задняя панель Neo1973 ==
-...изображена на нижеприведенной фотографии. Отчетливо виден логотип и текст OpenMoko.
+...изображена на нижеприведенной фотографии. Отчетливо виден логотип и текст Openmoko.
 [[Image:Gta01b v3 case back white.jpg|700px]]

@@ Line 86: / Line 86: @@
 {{Languages|Disassembling_Neo1973}}
-[[Category:Neo1973 Phase 1 related]]
+[[Category:Neo1973 Phase 1 related/ru]]
-[[Category:Neo1973 Phase 0 related]]
+[[Category:Neo1973 Phase 0 related/ru]]