Analogue wired Headset Nokia
The pinout of Nokia Phones is known to use the Nokia-wired-conectivity standard, which is:
- 1/Tip: left speaker/stereo or main speaker/mono
- 2: right speaker/stereo or not connected/mono
- 3: microphone and button (low resistance to ground on press)
- 4/Base: ground
This pinout is not compatible to Neo. To use Nokia headphones you have to rewire them swapping Tip and 3. Or use a simple adater doing this swap.
The following sections describe the modifications made to diferent models of headsets by its owners.
To reach the PCB you have to remove the bottom black piece of the gray case. It is glued with a soft adhesive, so simply pull out with a fingernail. Below this you can find one of the two screws. The upper black piece is now unlocked, and you only have to remove it to see the second screw. Now you have opened the case. Remember where the knots of the cables are, and pull out the PCB. You have to swap the red and white wires as seen in the picture (click on the image for full size).
You have to change the gain of the output in alsamixer from 80% to 95% due to different sensitivity (dBm/mW) of headphone speakers. Microphone works perfectly. Button may work (not tested).